Physics · Chapter 13

Electronics

2 topics · Updated 14 Nov 2026

A PN junction diode conducts in forward bias and blocks in reverse bias, so it can rectify AC into DC: half-wave (one diode) or full-wave (centre-tap with 2 diodes or a bridge of 4).

Introduction: semiconductors

Type Made by Majority carriers
Intrinsic Pure Si / Ge (4 valence e⁻) Equal electrons and holes
n-type Add pentavalent impurity (P, As, Sb): donors Electrons
p-type Add trivalent impurity (B, Al, Ga, In): acceptors Holes
  • Doping: adding a tiny amount of impurity to increase conductivity.
  • Both n- and p-type are electrically neutral.
  • Conductivity of semiconductors increases with temperature.

13.1 Rectification by diodes

Intro: Rectification is the conversion of AC into DC, done with diodes.

Half-wave (1 diode)Full-wave (2 or 4 diodes)AC input (dashed)AC input (dashed)output: only positive halvesoutput: both halves made positive
Rectifiers. Half-wave keeps half the cycle; full-wave uses both halves.
Half-wave Full-wave
Diodes 1 2 (centre-tapped transformer) or 4 (bridge)
Working Diode conducts only in positive half cycle; negative half blocked Diodes conduct in alternate halves; current through load in same direction both halves
Output Pulsating DC, gaps Pulsating DC, no gaps
Ripple frequency (50 Hz input) 50 Hz 100 Hz
Efficiency Low (≈ 40.6%) Higher (≈ 81.2%)
  • Bridge rectifier: 4 diodes; in each half cycle two diodes conduct in series; no centre tap needed.
  • Smoothing: a capacitor across the load charges at peaks and discharges in gaps → nearly steady DC.
  • Uses: battery chargers, DC power supplies of TV, computers, mobiles.

In a bridge rectifier only 2 of the 4 diodes conduct at a time.

MCQ TRAP: Rectification converts AC to DC (inverter does DC to AC). Full-wave output ripple frequency is double the input frequency.

You have read 1 of 2 topics for free

Revised this chapter? Test yourself